Falklands camera protection works best as layers: use a rain cover while shooting, a protected backpack or dry bag during transport, minimize lens changes in blowing weather, clean salt spray promptly and keep backups of both storage and essential accessories.
Wind: control loose gear
Secure straps, rain-cover fabric and tripod accessories before working on exposed coasts. Change lenses behind shelter when possible so wind-driven grit and moisture have less opportunity to reach the sensor or rear element.
Rain: weather sealing is not waterproofing
Even weather-resistant cameras benefit from a dedicated cover in sustained rain. Keep a dry cloth available for the exterior and a separate clean cloth for optical surfaces.
Sea spray: deal with salt carefully
Salt can remain after droplets dry. Keep the camera covered near breaking surf or small boats, remove loose contamination before wiping and clean according to the camera/lens manufacturer’s guidance after exposure.
Boat transfers
Put equipment into a sealed dry bag before a wet transfer rather than waiting for spray to start. Our camera dry-bag guide explains what to look for.
Condensation needs a different strategy
Moving cold camera gear into warm humid accommodation can cause condensation. Keep the camera inside its closed bag while it warms gradually instead of immediately exposing cold glass to indoor air. Pack silica gel only as a supplemental moisture-control tool, not as a substitute for drying wet equipment. Before the next day, inspect battery/card doors and make sure rain covers are dry.
